Caller-ID |
|
Calling Number Delivery (CND), better known as Caller ID, is a telephone service intended for residential and small business customers. It allows the called Customer Premises Equipment (CPE) to receive a calling party's directory number and the date and time of the call during the first 4 second silent interval in the ringing cycle. Caller-ID ParametersThe data signaling interface has the following characteristics:
Caller-ID ProtocolThe protocol uses 8-bit data words (bytes), each bounded by a start bit and a stop bit. The CND message uses the Single Data Message format shown below.
Caller-ID Channel Seizure SignalThe channel seizure is 30 continuous bytes of 55h (01010101) providing a detectable alternating function to the CPE (i.e. the modem data pump).
Caller-ID Carrier SignalThe carrier signal consists of 130 +/- 25 mS of mark (1200 Hz) to condition the receiver for data. Caller-ID Message Type WordThe message type word indicates the service and capability associated with the data message. The message type word for CND is 04h (00000100). Caller-ID Message Length WordThe message length word specifies the total number of data words to follow. Caller-ID Data WordsThe data words are encoded in ASCII and represent the following information:
If the calling party's directory number is not available to the terminating central office, the data word field contains an ASCII "O". If the calling party invokes the privacy capability, the data word field contains an ASCII "P". Caller-ID Checksum WordThe Checksum Word contains the twos complement of the modulo 256 sum of the other words in the data message (i.e., message type, message length, and data words). The receiving equipment may calculate the modulo 256 sum of the received words and add this sum to the received checksum word. A result of zero generally indicates that the message was correctly received. Message retransmission is not supported. Example Caller-ID Data MessageAn example of a received CND message, beginning with the message type word, follows: 04 12 30 39 33 30 31 32 32 34 36 30 39 35 35 35 31 32 31 32 51
Caller-ID Data Access Arrangement (DAA) RequirementsTo receive CND information, the modem monitors the phone line between the first and second ring bursts without causing the DAA to go off hook in the conventional sense, which would inhibit the transmission of CND by the local central office. A simple modification to an existing DAA circuit easily accomplishes the task. Caller-ID Modem RequirementsAlthough the data signaling interface parameters match those of a Bell 202 modem, the receiving CPE need not be a Bell 202 modem. A V.23 1200 bps modem receiver may be used to demodulate the Bell 202 signal. The ring indicate bit (RI) may be used on a modem to indicate when to monitor the phone line for CND information. After the RI bit sets, indicating the first ring burst, the host waits for the RI bit to reset. The host then configures the modem to monitor the phone line for CND information. Caller-ID SignalingAccording to Telcordia specifications, CND signaling starts as early as 300 mS after the first ring burst and ends at least 475 mS before the second ring burst Caller-ID ApplicationsOnce CND information is received the user may process the information in a number of ways.
Additional Information Regarding Caller-IDFor more information on Calling Number Delivery (CND), refer to Telcordia publications TR-TSY-000030 and TR-TSY-000031. To obtain Telcordia documents contact: blog comments powered by Disqus |
Discuss Caller-ID in the forums.

